Aiphone GT Video-intercom System Guide
GT Standard Configuration
The Standard Configuration for a GT video-intercom system is illustrated below.
The configuration from the residence (or tenant) trunk lines to the tenant monitor
stations is the same for the Standard and the Expanded Configurations, and is
illustrated is a subsequent section.
The video output from the video entrance station is connected to the GT-VBC Video
Bus Control Unit, which has 6 trunk line outputs.
The audio and control output from the entrance station is connected to the GT-RC
Bus Control Unit, and then out to 6 trunk lines from a Distribution Point (that must
be provided by the installer).
The separation of the video and audio/control distribution allows an audio
intercom-only system to be implemented by omitting the video component of the
modular entrance station, the GT-VBC, and all of the video distribution cabling.
There is a table in the GT video-intercom installation manual indicating the
maximum cable distances between all GT modules, depending upon the gauge of
PE cable used. The 0.8mm column should be used from this table if 0.9mm PE
cable is being used in the installation.
While only one modular entrance station is shown above, any of the modular
entrance stations, or the integrated entrance station may be used. Also, multiple
entrance and concierge stations are supported, as indicated in the “Maximum
Supported Modules” table above.
Comments to this Manuals