Aiphone JK-1MD User Manual download pdf (Page 8)

- 8 -

EnglishFrançaisEspañolNederlandsItaliano

6-3 Entrance monitoring

Press MONITOR button in the standby mode.

The video monitor displays the image from the door station and the

incoming audio is heard. If you do not press

TALK button, the

caller will not hear sounds from the inside station.

Press OFF button to end communication.

NOTES:1. To talk to the entrance during entrance monitoring, momentarily

press

TALK button. This allows communication with the entrance.

2. The entrance monitoring turns off automatically after approx. 1

minute. To monitor the entrance again, repeat from the beginning.

3. During entrance monitoring, the monitoring time can be extended by

approx. 1 min. by pressing

MONITOR button.

4. During entrance monitoring, the wide picture display is used. Press

ZOOM/WIDE button to switch to the zoom picture.

5. At night, the Illuminator LED will not light up until

TALK button

is pressed.

6. If another inside unit attempts to perform entrance monitoring while

one inside unit is already doing so, a warning beep sound will occur.

6-4 Room-to-room communication

Press CALL button to talk with the other person.

• A call-in is sent to the sub station.

• The reply of the other person is not heard.

If the other person presses TALK button, hands free

communication is possible.

Press and release OFF button to end communication.

NOTES: 1. Room-to-room communication ends automatically after approx. 10

minutes.

To perform room-to-room communication again, repeat from the

beginning.

2. If a call is received from the entrance during room-to-room

communication, the image from the entrance is displayed at the

monitor station and sub station where communication is taking

place. Press

OFF button to end the room-to-room communication,

and press

TALK button to switch to communication with the

door station.

6-5 Wide/Zoom switching

Press ZOOM/WIDE button when a picture is displayed.

Switching between wide ⇔ zoom occurs each time the button is

pressed.

[Wide picture] [Zoom picture]

NOTES: 1. When the caller is not shown in the center of the picture, the zoom

picture can be moved up, down, left, and right. (Refer to section

6-6)

When switching from the wide picture to the zoom picture, the

zoom picture starts at the pre-set (section 6-7) position.

The wide picture may be distorted in comparison with the zoom

picture due to the characteristics of the door station camera, but this

is not a malfunction.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Aiphone JK-1MD User Manual Page 8

Comments to this Manuals

Related products and manuals for Video surveillance systems Aiphone JK-1MD